VEVOR BT-RTR08-DCG Bedienungsanleitung Seite 9

STEP 8
Insert the front faceplate into the circular cutout, ensuring the mounting
holes align.The cylinder should easily slide into the rear faceplate's
cylinder.
The front faceplate should be installed on the wall where the hole was
drilled in Step 5.
STEP 9
Route the power cord through the opening at the lower right corner to
ensure the front faceplate is flush against the wall.
STEP 10
Secure the front faceplate by drilling the screws into the anchors.
- 8 -