VEVOR BT-RTR08-DCG Bedienungsanleitung Seite 8

STEP 5
Drill the mounting holes into the wall. Use a saw or other tool to open the
center hole and ensure that the hole is circular.
We recommend that the inner diameter of the four small holes on the
outside be 6mm The inner diameter of the central hole is 211mm.
STEP 6
Insert the plastic expansion screw into the hole through 4 small holes
STEP 7
Secure the rear faceplate by drilling the screws into the anchors.The rear
panel needs to be installed on the wall where the drilling was done in Step
2.
- 7 -