HOMCOM DEI23A-B Bedienungsanleitung Seite 19

EN
Press the "+" or "-" to change the serial number until you get the serial number of
setting that you need to set or modify.
(II) Select day
Press " " button once again, and the cursor on the left side of day starts blinking
Press the "▲" or "▼" keys to move the cursor to the corresponding day, press the "+"
to add the corresponding day, or press "-" to delete the day.
(III) Set the power-on time
Continue to press the "
Press the "+" or "-" to adjust the hour.
Continue to press the "
Press the "+" or "-" to adjust minute.
(IV) Set the power-off time
Then press the "
Press the "+" or "-" to adjust the hour.
Continue to press the "
Press the "+" or "-" to adjust minute.
(V) Set temperature
Then press the "
moment, the temperature displayed is normally set temperature, which can be
adjusted by pressing "+" or "-"
(VI) Press "
setting.
7. Timer switch
" "button is to control the timed opening and closing.
Restart the machine after power is cut off, the original setting is kept, but the current
day and time must be reset.
NOTE: When the timer is active, the heating level must be manually selected. If the
heater function is not selected, only the flame effect goes on at the set power-on time.
Safety Cut-Off
• This appliance is fitted with a safety cut-off which will operate if the fire overheats
(e.g. Due to blocked air vents). For safety reasons, the fire will NOT automatically
reset.
• To reset the appliance, disconnect the appliance from the mains supply for at least
15 minutes. Reconnect the supply to the mains and switch on the appliance.
Bulbs replacement
" button, the hour starts blinking.
" button, the minute starts blinking.
" button, the display is off, and the hour starts blinking.
" button, the minute starts blinking.
" button, and the temperature set starts blinking. At this
" button to continue setting, and press "
19
" complete the