HOMCOM DEI23A-B Bedienungsanleitung Seite 17

EN
2. Boot steps
1) Connect the power
2) Turn on the power switch
3) Press the control switch or "
4) Press the
setting, press third time to switch off the heat setting.
Note: When the high heating is power off, the indicator light and LED screen
showing will flash to heating off.
Note: The set temperature must be higher than the room temperature for the heat
working.
5) Press the
choice. The LED screen will show b00, ..., b12, b- -(no back light), b00(all colors
loop).
6) Press the
brightness available.
3. Automatic heating
Press the "lC" key to activate automatic heating mode. The "AUTO" icon appears on
the display, the set temperature is reduced to save the energy, press again, exit the
automatic heating mode, the "AUTO" icon extinguished.
Note 1: In the automatic heating mode, the 24 hours have been divided into two
periods, low-power mode and comfort mode. In the low-power mode time, the set
temperature is reduced to save the energy, the set temperature is unchanged in
comfort mode.
Note 2: The initial low power consumption period is 8:00-17:00.
Note 3: In the automatic heating mode, this function only has an effect on the set
temperature when heating function is on.
Automatic heating mode operation
1)To set the start time for the low power consumption time period, press the key "▼",
the "ON" icon appears on the display, come into the start time setting, the hour digit
start flashing, press the '+' '-' key to adjust the hour. Press the key again, the min
digit start flashing, press '+' '-' key to adjust the minutes. After the setting is
finished, press the key "▼" or "
seconds can also exit the setting.
2) To set the end time for the low power consumption time period: Press the key "▲",
the "OFF" icon appears on the display, come into the off time setting, the hour digit
start flashing, press the '+' '-' key to adjust the hour. Press the key "▲" again, the
min digit start flashing, press '+' '-' key to adjust the minutes. After setting is
finished, press the key "▲" or "
seconds can also exit the setting.
Note: If the OFF time is earlier than the ON time, the off time is in the next day.
3) Press the "+" or "-" button to set the temperature, which ranges from 15 to 30 ℃.
" key of the remote controller to start up
button once for the low heat settings; press twice for the high heat
button for back light color change, there will be 12 colors for
button for operate the dimmer mode, there are 5 levels flame
"to exit the setting, no operation within ten
" to exit the setting, no operation within ten
17