HOMCOM DEI23A-B Bedienungsanleitung Seite 18

EN
Note: If the automatic heating mode function is in the week timer period, it will use
the temperature in the week timer.
4. Setting the weekday and time
① Settings are done on the remote controller.
② Press " " button, then press the "▲" or "▼" key to select the day.
③ Press "
" button again, then press the "+" or "-" to set the hour.
④ Press " " button again, then press the "+" or "-" to set the minute.
⑤ Press " " button to complete.
5. Temperature setting
The default set temperature is 30 ℃, press "+" or "-" on the remote controller to set the
temperature, which ranges from 15 to 30℃, and this is the normally set temperature
(the timer is off)
Note: The set temperature must be higher than the room temperature for the heat
working.
6.Timer setting
① Description of setting
There are up to 10 items for timer setting
Each timer setting has its day, power-on time and power-off time
The maximum duration of each timer setting is 23 hours 50 minutes
The set day for each timer can be any day or days of a week
The day in each timer setting represents the day of power-on time
If the power-off time being set falls on the second day, it is unnecessary to set the day
– you just set the power-off time
② Steps to view the timer setting
Press the "
Press the "+" or "-" to check the power-on time of the set timers one by one.
For checking the power-off time, press the "▲" button
Press the "+" or "-" to check the power-off time of the set timers one by one.
To delete the selected setting, press "
③ Time setup steps for timer setting
(I) Select the settings
Press the "
" button
" button, and the serial number of setting starts blinking(01-10).
" key.
18