Behringer UB-Xa MINI Kurzanleitung Seite 9

16
UB-Xa MINI
UB-Xa MINI Controls
25. MEMORY/WRITE – hold this
button to select a new sequence
memory, in conjunction with
keys 28 – 37; or with FUNC (3) to
write the sequence.
26. RECORD/ERASE – use this
button to set the sequencer
recording; or with FUNC (3) to
erase the current sequence.
If the sequence is not saved
then the buffer will be erased.
Sequencer has to be running
to erase.
27. PLAY/ACTIVE – use this button
to play the selected sequence;
or with FUNC (3) to activate
or deactivate steps from the
sequence. The active steps are
indicated by the LEDs in the
keyboard keys.
28. CLEAR ACTIVE STEP – use this
key to undo the Active Step
select by button 27 and revert
the sequence to its original form.
Also used to select memory 1.
29. CLEAR ALL – use this button
to clear all sequencer buffer.
Also used to select memory 2.
30. SCALE 1/1 – Sequencer and
Arpeggiator will run at selected
tempo. Also used to select
memory 3.
31. SCALE 1/2 – Sequencer and
Arpeggiator will run at half
selected tempo. Also used to
select memory 4.
32. SCALE 1/4 – Sequencer and
Arpeggiator will run at quarter
selected tempo. Also used to
select memory 5.
33. METRONOME – use this key to
switch the metronome on or
off when recording sequences.
Also used to select memory 6.
34. STEP TRIGGER – forces an
envelope re-trigger with each
new sequence step. Does not
function when in Freestyle
mode. Also used to select
memory 7.
35. FREESTYLE – use this key to
put the sequencer into real time
recording mode. Also used to
select memory 8.
36. MOTION SEQUENCE ON/OFF
– use this key to allow the
real-time recording of control
changes into a sequence once the
notes have been recorded. Please
note that VCF Resonance, Tempo
and VCO waveform cannot be
recorded into a motion sequence.
Also used to select memory 9.
37. MOTION SEQUENCE SMOOTH
– use this key to smooth out
control changes recorded into a
motion sequence. When Smooth
is off then the motion sequence
will jump between steps. Also
used to select memory 10.
38. MOTION SEQUENCE CLEAR –
use this key to clear a motion
sequence that has been recorded.
39. 4 POLE – use this key to select 4
pole slope for the VCF. If the LED
is not lit then the VCF will have a
2 pole slope.
40. LFO SINE – use this key to select
a sine wave for the LFO.
LFO SAW – use this key to select
41.
a sawtooth wave for the LFO.
Quick Start Guide
LFO SQUARE – use this key to
42.
select a square wave for the LFO.
43. LFO TRIGGER SYNC – use
this key to select LFO Trigger
Sync, which resets the LFO
with each new key played
when operational.
17