Installation Guidelines - HEYLO DE 10 E Bedienungsanleitung

4. Installation guidelines

1. Installation location
Devices must not be operated at locations, where ignitable gas, air or dust-air mixes
occur (e.g. gas stations, paint shops) and also not at locations, where they can suck in
flammable small parts, which could ignite on the heater coil and be blown out blistering
(e.g. straw, paper, sawdust).
Devices DE 10 E, DE 20 and DE 30 must not be connected to air ducts and hoses.
Electric heaters DE 20 S and DE 20 SH are suitable for the duct operation with a
maximum duct length of 7.5 m (diameter 305 mm). It should be ensured to route the
ducts as straight as possible and without any bends. In case of improper duct routing
the device overhears and the safety temperature limiter switches the device off.
2. Installation
Electric heaters must not be operated in the direct proximity to bathtubs, showers,
sinks or swimming pools.
3. Safety distance to flammable parts:
Laterally: 0.60 m
Intake side: 0.20 m
The electric heaters must not be covered with clothing!
Floor and ceiling must be fire-resistant. Intake and exhaust nozzles should not be
narrowed.
4. For operation at construction sites the safety guidelines of the Construction
Employer's Liability Insurance Association must be observed.
5. For operation in agriculture the provisions of the Agriculture Employer's Liability
Insurance Association and Property shall apply.
6. Statutory provisions: the following provisions must be observed during installation
and setup:
Workplace Ordinance §§ 5 and 14
Workplace Directive ASR 5
Accident Prevention Regulations VBG 43
available from: German Center of Information for Technical Rules (DITR) in DIN,
Burggrafenstraße 6, 10787 Berlin).
7. The device must not be operated underneath wall outlets.
8. The device must not be operated unattended via timer.
Blowing out side: 2.00 m
Upwards: 2.00 m
21 EN