Installation Guidelines - HEYLO DE 9 XL Bedienungsanleitung

After shutting off, the fan will continue
When the switch 1 is switched on ventilation is, only the fan motor.
Switch 2 (temperature thermostat)
In the heating mode to regulate the room temperature between 5°C and 40°C is possible
Switching off
After switching off, then have to wait until the fan turns off. Only then should the plug be pulled.

4. Installation guidelines

1. Place of installation
The appliances cannot be operated at place where there are ignitable gas, air or gas/air combinations
(e.g. petrol pumps, paint workshops, etc.) and also not where they can suck in small combustible
parts, that can be lighted up at the heating coil and blown out as glowing sparks (e.g. straw, paper,
sawdust and wood shavings, etc.)
The appliance cannot be connected to air conduits or hoses. The device should not be exposed to
heavy dust emissions. Dust deposits on the PTC heating element can cause a short circuit in
connection with humidity.
2. Installation
Electric heaters cannot be operated in the immediate proximity of bathtubs, wash basins or
swimming pools.
3. Safety distances to combustible parts:
On the side: 0.60 m
Suctioning side: 0.20 m
Do not cover electric heaters with textiles!
Floors and ceilings must be fire resistant. Suctioning and blowing out pipes should not be
narrowed.
4. When using on a construction site, the safety guidelines of the professional construction
associations must be maintained.
5. When using in agriculture, the regulations of the agricultural professional associations and
property insurers apply.
6. Legislation: the following regulations must be observed when installing and starting up:
Work place ordinance §§ 5 und 14
Work place directive ASR 5
Accident prevention regulations VBG 43
available at: German Information Centre for Technical Regulations (DITR) at DIN,
Burggrafenstraße 6, 10787 Berlin).
7. The appliance cannot be operated under wall sockets.
8. The appliance cannot be operated by a programmable timer without supervision.
until no more residual heat is present (after-cooling function).
Blow out side: 2.00 m
Upwards: 2.00 m
10
EN