Battery Information - Learning Resources Botley The Coding Robot 77-Piece Activity Set Spielvorschläge

7. If/Then/E1s e
Program Botley to move
forward 3 steps to get to
the orange board. Then,
use Object Detection to
go around the blocks.
9. Mak e aSquare
Using the LOOP command, program Botley to
move in a square pattern.
8
8.
Nowhere to Run
Using Object Detection,
program Botley to keep
turning around between
the objects.
10. Combo C hallenge
Using both LOOP and Object
Detection, program Botley to
move from the blue board to
the green board.
Battery Information
When the batteries are low on power, Botley will beep
repeatedly. Please insert new batteries to continue using
Botley.
Installing or Replacing Batteries
WARNING! TOavoid battery leakage, please follow these
instructions carefully.
Failure to follow these instructions can result in battery acid
leakage that may cause burns, personal injury, and property
damage.
Requires: 5 x 1.5V AAA batteries and a Phillips screwdriver
Batteries should be installed or replaced by an adult.
•
Botley requires (3) three AAA batteries. The Remote
•
Programmer requires (2) two AAA batteries.
On both Botley and the Remote Programmer, the
•
battery compartment is located on the back of the unit.
To install batteries, first undo the screw with a Phillips
•
screwdriver and remove the battery-compartment
Install batteries as indicated inside the compartment.
Replace compartment door and secure with screw.
•
e
AAA size
e
Battery Care and Maintenance Tips
Use (3) three AAA batteries for Botley and (2) two AAA
•
batteries for the Remote Programmer.
Be sure to insert batteries correctly (with adult
supervision) and always follow the toy and battery
manufacturer's instructions.
Do not mix alkaline, standard (carbon-zinc),
rechargeable (nickel-cadmium) batteries.
Do not mix new and used batteries.
•
Insert battery with the correct polarity. Positive (+)
•
and negative (-) ends must be inserted in the correct
directions as indicated inside the battery compartment.
Do not recharge non-rechargeable batteries.
•
Only charge rechargeable batteries under adult
•
supervision.
Remove rechargeable batteries from the toy before
•
charging.
Only use batteries of the same or equivalent type.
•
door.
Do not short-circuit the supply terminals.
•
Always remove weak or dead batteries from the
•
product.
Remove batteries if product will be stored for an
•
extended period of time.
Store at room temperature.
•
To clean, wipe the surface of the unit with a dry cloth.
•
Please retain these instructions for future
•
or
reference.
9