Sharp RP-200H Bedienungsanleitung Seite 5

5 TURNTABLE LOCATION
To prevent howling (feedback
whistle) and stylus skipping,
place the turntable unit as far
away from the spea kers as
possible.
TRANSPORTING
6
When changing
recommended
the rest to prevent the stylus from hitting
hard objects.
with use of CUT button
OPERATION
SWITCHING SPEED
1
The SPEED selector Of this unit can be changed only when the turntable
platter is rotating. Even if the SPEED selector is switched when the turn-
table platter is not moving, the speed will not change.
Observe the follbwing procedure when Changingturntable speed.
I , Remove
2 3
2. Move the
wards.
3. Hold the headshelj grip and swing the tone-
arm over the turntable
2 AUTOMATIC PLAY
Non-standard record diameters such as records that are not 30cm (12")
or 17cm (7") require manual starting.
(Manual starting is also required if standard records are started at
mid-record.) Refer to the instructions for "MANUAL
5.
Switch
2. Switch
to
Place a record on the
3.
the mat)
4. To
4
supplied.
5. Set
(17cm
position
6. Switch
"SWITCHING
this page.
7. Move
front.
Push
8.
swings
descends.
Adjust amplifier volume and tone controls
9.
to appropriate
2. Place the turntable
surface that isn't affected
local vibration — door
ming, floor vibrations,
UNIT
the location of the unit,
that you clamp the tonearm to
Return the tonearm to the rest
or manually.
SELECTOR
the tonearm clamp.
cuing/pause control
platter.
NOTE:
PLAY" on page
on amplifier power.
the function selector of the amplifier
the PHONO position,
a 45 rpm record, use the adaptor
play
record SIZE selector to
the
- 7 in.) or "30" (30cm
-
.
the SPEED selector.
SPEED SELECTOR"
cu ing/pause control lever to the
the
the PLAY button and the
the outer edge Of the record and
to
leve Is.
AMPLIFIER
7
I. With the amplifier power switch turned off, connect the output cable
ptug of the turntable unit to the amplifier PHONO socket.
2. Plug the AC supply lead of the turntable
mains outlet.
RP-200H
unit on a
by
slam-
etc.
it is
any
33-1/3 rpm
45 rpm
lever back-
platter (on
CAUTIONS
the "17"
Do not interfere
- 12 in.)
return to the arm rest or during
Do not rotate the turntable
2.
di rection.
Do not touch
3.
objects
Refer to Never move the cuing/pause control
4.
on
tonearm clamp is fixed.
The tonearm will not return to its rest automatically
5.
record with less than 4mm between the innermost
a recorded signal and the last groove of a record.
the CUT button
tonearm
tonearm rest.
Do not change the record
6.
rnotion or just after the stylus descends on the record surface. This
action leads
If the stylus cannot
7.
descending position of the stylus must be readjusted precisely.
Refer to the instructions
Move the cuing/pause
8.
PLAY button
you don't do this, major damage may be caused to the stylus
CONNECTION
/HB
socket
Switch the SPEED
4.
(33-1/3 rpm) or
to match the speed
played.
After selecting speeds, return
5.
its rest manually,
10. The cuing/pause
interrupts record
resumes at the point
the cuing/pause
in order to lift the tonearrn.
Restart record play by sliding the cuing/
pause control lever forwards.
11. To discontinue
push the CUT button.
return to the tonearm
power will be
12. The tonearm automatically
tonearm rest and
turned off at the end of record play.
WHEN PLAY ING RECORDS
vvith the movement of the tonearm
auto lead-in.
platter by hand in an anti-clockwise
the stylus with either your
lever backwards while the
and the tonearm will automatically
SIZE selector
to turntable trouble.
descend on the starting
on page 5.
control lever backwards
has been pushed With no record on the turntable.
unit into a convenient AC
To an AC outlet
Amplifier
(SA-200H/HB, etc.)
selector to the "33"
"45" (45 rpm) position
of the record bei ng
tonearm to
or push the CUT button.
control lever operation
play and further operation
of interruption. Move
con trol lever backwards
record play at any point,
The tonearm will
rest and turntabie
turned off automatically.
returns to the
the turntable power is
during its
fingers or with any hard
after playing a
groove containing
In this case, push
return to the
when the tonearm is in
groove precisely, the
quickly when the
If
4