VEVOR HJ-RB021 Bedienungsanleitung Seite 5

A. Installation step 1：
The fixing plate should be installed
tightly against the front clamp
position.
1. Firstly, install the screws & flat washers & square nuts together, and then install
them into the slot of the aluminum tube.
front of the front clamp of the adaptor and should be tightly against the front clamp
to prevent loosening of the adaptor clamp.
2. Install the four adaptors into the grooves on both sides of the cross bars, then
install and fix each bar plug on the cross bar, and then install the bar plug after the
cross bar is completely installed and fixed on the roof rack.
B. Installation step 2：
OPERATION
Install the fixing plate at the
position shown in the picture.
Attention: The screw plate is installed in