Holzmann UWS3 Bedienungsanleitung Seite 13

4 CAUTIONS
Please reading the manual carefully before using the machine and
check it and the accessories according to the packing list. Be sure to in-
stall and test the machine according to the instructions.
4.1 Preventative Measures
1. Only professionals with electrician licenses are authorized to install or repair electrical ap-
pliances.
2. Be sure the voltage indicated on the nameplate of the motor conforms to that of the power
supply.
3. The power plug of the machine tool and each contact of the socket should be reliable and
firm. It is forbidden to have loose or bad contact.
4. Only use authorized power cords. Don't pull the power cord from the socket violently. The
power cord should be away from hot, oily, or sharp places.
5. The power supply should be cut off by turn off the switch on the left side of the machine
tool as soon as any fault or abnormal sound is detected, then have it checked and re-
paired.
6. Never leave the tool run unattended. Don't leave the tool until it is powered off and stops.
7. Keep the operating place clean and tidy. Don't operate it in any damp, untidy, dim, flam-
mable, and explosive place. Keep children or visitors away from the tool to avoid acci-
dents.
8. Keep it under its max. cutting capacity to avoid accidents.
9. No operator should wear loose clothes, ornaments, gloves. Long hair should be fixed with
a hair pin and tucked in a cap, otherwise, it may be rolled into the machine.
10. All work pieces should be held and clamped tightly and reliably in processing. Never hold
one with your hand, if so, you can not operate the machine with two hands.
11. Never operate the machine when you feel tired, or after you drink alcohol or take anes-
thetics.
12. Only replace damaged parts or accessories with those having the same performance. It is
optimal to use those from our company.
4.2 Adjust and Operate
1. Before starting the machine, add lubricants in each part and ensure that all locking mech-
anisms are in proper locking and power supply is proper.
2. Sand should be removed from the machine after operation, and apply engine oil on un-
coated surface to prevent it from becoming rusty.
HOLZMANN Maschinen Austria
A T T E N T I O N
www.holzmann-maschinen.at Seite 13
tool grinding machine UWS3