Completion Of Operation; Cleaning And Care; Notes On Stainless Steel (Risk Of Corrosion!) - Salvis ProfiLine GN 2/1 Betriebsanleitung

6.

Completion of operation

. Switch off the appliance - Press and hold the key "On/Off" for 3 seconds.
3 sec.
● The indicator light in the key goes out.
● Three dots glow on the display.
. Clean the appliance - see the following 7. "Cleaning and Care" chapter.
. Turn off the fitted mains switch.
7.

Cleaning and Care

CAUTION!
● Do not apply any caustic cleaners to the control panel or rotary handles!
● Do not spray or clean the appliance with water hoses, high pressure cleaners, high pressure
steam cleaners or steam cleaners!
● Follow the instructions supplied by the manufacturer of the cleaning product!
● Do not use any scouring cleaning product or damaged cleaning scrapers! These cause
scratches.
● Stainless steel may not come into prolonged contact with concentrated acids, essence of vinegar,
salt solution, mustard or spice mixtures. Prolonged contact with these substances will damage
the protective coating. After use, rinse stainless steel surfaces until water runs clear.
Cleaning and maintenance material
Suitable cleaning and care products can be obtained from your Customer Service agent.
For example:
‒ cleaners which dissolve fat or special stainless steel cleaners,
‒ grill cleaners for stainless steel,
‒ protective stainless steel cleaners,
‒ cream cleaner for frying surfaces.
7.1

Notes on stainless steel (risk of corrosion!)

● Please note! Even high-quality stainless steel can corrode if handled improperly. Salt, acids, chlo­
rine, iodine and food residues destroy the protective coating and can result in corrosion and pit­
ting, also with high-quality stainless steel!
● The stainless steel surface creates a new protective layer immediately after damage, but only if
air or oxygen-rich water has time to react with the surface.
● If residues, e.g. lime, protein or starches are not completely removed, it prevents air or oxygen-
rich water from getting to the stainless steel surface. A protective coating cannot be formed and
this causes corrosion e.g. pitting damage, even on high-quality steel. Therefore, clean thoroughly
to prevent residues from sticking.
en
43 / 76