Fuxtec FX-RM Serie Bedienungsanleitung Seite 68

Manual_FX-RM_Series_Int24_rev24
Clean the device carefully with water after each cutting operation. Remove the grass and mud
deposits that have accumulated inside the undercarriage. This will avoid drying out and
possible difficulties when starting the engine again.
You can use the EASY CLEAN connection to clean the inner
housing (cutting unit). Simply connect a water hose to the
connection on the top of the housing and slowly turn on the
water while the cutting mechanism is running. The rotation of the
cutting mechanism distributes the water evenly in the inner
housing and can thus flush away dirt residues.
The paint on the inner side of the undercarriage may flake off over
Easy Clean
time due to aggressive operations. In this case, you should paint over the paint with rust-
resistant paint to protect the undercarriage from the corrosion of the metal.
Check the V-belt 1-2 times a year and remove any cuttings from it.
Once a year, the drive wheels should be cleaned inside.
Remove both wheels. Use a brush or compressed air to remove grass and dirt from the gear
wheel and gear rim.
68