User manual and warranty card
English
To remove the battery, press the battery release button and slide the battery rearward and
pull it out of the tool.
START-UP
To start the appliance, press the switch lock 1 (Fig. 9) and simultaneously press the switch 2
(Fig. 9).
Remember not to operate the trimmer in the presence of bystanders. Clean the area before
starting work.
• The switch-off occurs as soon as any of these buttons are released.
OPERATION
Operating the trimmer should not be a problem. Be sure to follow the safety instructions in
this manual. Thanks to the adjustment system, the trimmer can be used to cut grass even in
hard-to-reach places, such as the area under benches, at curbs and parklands. The use of
wheels allows you to cut the grass in a vertical position.
ADJUST CUTTERBAR TILT ANGLE
The cutterbar angle adjustment is shown in Fig. 9. The cutterbar tilt pivot allows adjustment
from 0° to 90° in five positions. To change the tilt angle, press the adjustment button 15 (Fig.
10) and while holding the cutterbar, tilt the cutterbar tube to the desired position.
ADJUSTING THE LENGTH OF THE TELESCOPIC TUBE
The length of the telescopic tube at the end of which the cutting unit is mounted can be
adjusted. For this purpose, the length of the telescopic tube is locked. The adjustment is
shown in Fig. 11.
To change the length of the telescopic tube:
• Turn the adjustment ring clockwise 1 (Fig. 11), slide the tube to the desired length,
• Lock the telescopic tube in this position by turning the locking ring counterclockwise 2
(Fig. 11). *
* - looking from the operator's side.
ADJUSTING THE ANGLE OF ROTATION OF THE MAIN HANDLE
The adjustment of the angle of rotation of the handle is illustrated in Fig. 12.
The adjustment is possible in eight positions, in the range of 0-120°.
To rotate the handle:
• Press the telescopic tube lock button 1 (Fig. 12),
• At the same time, turn the handle clockwise 2 (Fig. 12). *
* - looking from the operator's side.
23