Charging The Battery - Murray Mu-Bat-Gt30-Kit Bedienungsanleitung Und Garantiekarte

User manual and warranty card
12. A spool with a line
13. Cutterbar guard
14. Knife for cutting the line
15. Cutterbar tilt adjustment button
16. The crop protection bracket
17. The battery
18. Charger
ASSEMBLY
Connecting the top shaft to the telescoping hook-up
• Align the arrow on the end of the telescoping shaft with the arrow on the upper shaft
and install the upper shaft on the telescoping shaft.
• Then use a hex wrench to tighten the screw.
Install crop protection cab and cutterbar shield
The cover is an essential function of the device and must always be used. Failure to do so
may damage the trimmer and injure the operator. The cover is not pre-installed on the
trimmer as it could be damaged during transport.
• Insert the metal bracket into the hole in the motor housing, paying attention to the
direction of fitting. (Fig. 3)
• Slide the cutterbar cover over the head housing, positioning the cover so that the hole in
the cutterbar cover matches the shape of the mounting bracket.
• Turn the bezel clockwise as shown by the arrow on the bezel to make sure it has entered
the slots.
• Install the screw in the visible hole.
Assembly of wheels
The trimmer is equipped with guide wheels for easy trimming of the grass along the edges
and in a vertical position.
• Locate the retaining pin located in the engine housing.
• Slide the wheels in the direction of the arrow. Make sure that the wheels are securely
fastened.

CHARGING THE BATTERY

The supplied battery is only partially charged, so you should charge it before use to avoid
possible problems.
ATTENTION! The batteries do not reach full charge when charging for the first time.
Several cycles (charging and discharging) are required to achieve full battery efficiency. The
battery should only be charged indoors. The battery may be warm when charging, this is
normal.
21
English