Personal Safety - Murray Mu-Bat-Gt30-Kit Bedienungsanleitung Und Garantiekarte

User manual and warranty card
 If the power cord is damaged during use, switch the device off and pull the plug out of the
socket.
 Devices operating in the 1st class of electrical protection must be connected to the
electrical installation with a protective pin. This is necessary for the user's safety.

PERSONAL SAFETY

 Be foresightful, watch what you do, and use common sense when working with
electrically powered equipment. Do not use the equipment when you are tired or under
the influence of drugs, alcohol or medication. A moment of inattention during work can
cause serious personal injury.
 Protective equipment should be used. Always wear safety glasses. Wearing protective
equipment such as a dust mask, non-slip shoes, helmet or hearing protectors under the
right conditions will reduce personal injury.
 Avoid unintentional start up. Make sure the power tool switch is in the off position
before connecting to the power source and / or connecting the battery. Before lifting or
carrying the device, make sure that the power cord is disconnected from the mains and
that the switch is in the "off" position. Carrying power equipment with your finger on the
switch or plugging into mains while the switch is on may result in an accident.
 Before starting the equipment, remove all objects and keys. Leaving the key in the
rotating working part of the device can cause personal injury.
 Do not lean too far. You should always stand firm and keep your balance. This will allow
better control in unpredictable situations.
 Dress properly. Do not wear loose clothing or jewelry. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewelry or long hair can be caught in moving
parts.
 When working, hold the tool by the additional handles if the tool is equipped with them.
Losing control of the tool carries the risk of injury.
 Do not use the device if you have trouble turning it off. Any device that cannot be turned
off is dangerous and must be repaired.
Caution! Despite the use of a safe structure by design, the use of protective
measures and additional protective measures, there is always a residual risk of injury
during work.
USE AND CARE FOR EQUIPMENT
 Do not overload electrically powered tools. Use the device with a power output
appropriate for the work. The correct electrical device will allow you to work better and
safer at the load for which it was designed.
 Do not use an electric device if the switch does not turn it on and off. Any device that
cannot be turned on or off with a switch is dangerous and must be repaired.
13
English