Murray MU-BAT-GT30-KIT Bedienungsanleitung Und Garantiekarte Seite 22

User manual and warranty card
 Do not place the charger in an area of extreme heat or cold, room temperature will be
the most suitable.
 When the battery is charged, disconnect the charger from the power supply and remove
the battery.
ATTENTION! Do not charge a hot battery. After the charging process, let the battery
cool down completely.
ATTENTION! Check the appliance before charging. Do not charge a cracked or leaking
battery.
ATTENTION! Always make sure you are using a genuine and compatible battery
before charging. Do not attempt to charge a battery that does not fit the charger.
After the battery has been charged and cooled down, you can insert the battery into the
appliance and start working with the equipment.
To charge the battery:
 Connect the charger (Fig. 6) to a power outlet. The green LED lights up.
 Insert the battery (Fig. 7) into the charging dock, the red LED lights up to indicate that the
charging process has started.
 When the green LED lights up, the battery is fully charged.
ATTENTION! The battery may become hot during the charging process, this is normal,
but in this case you must wait before installing the battery to the appliance until it cools
down.
*Expected operating time of the device with batteries of different capacities:
The battery
20V 3.0 Ah
20V 4.0 Ah
*the estimated operating time cannot be determined precisely, because it depends on
factors such as: intensity of use, ambient temperature, time between charging the battery
and its use.
For your comfort, it is recommended to purchase an additional battery (the same or
higher capacity) to extend the operating time of the device without major interruptions
to recharge the battery.
FIT THE BATTERY
Insert a functioning and charged battery into the trimmer battery socket as shown in Fig. 8
until it clicks into place.
Working time
30 min.
40 min.
22
English