Dell PowerVault MD3200 Handbuch Zum Einstieg Seite 16

LED Indicators (continued)
RAID controller module
Switch
System identification button
Enclosure mode switch
Password reset switch
Power Supplies
AC power supply (per power supply)
Wattage
Voltage
Heat dissipation
Maximum inrush current
14
Getting Started With Your System
Six single-color LEDs:
• One battery fault
• One cache active
• One controller fault
• One controller power
• One system identification
• One management Ethernet activity
Six two-color LEDs:
• Four SAS IN link or fault
• One SAS OUT link or fault
• One management Ethernet link speed
Located on the front control panel. This button is
used to locate a system within a rack.
Located on the front of the system. This switch is
not applicable to the PowerVault MD3200 series
storage array.
Located on the back-panel of the RAID controller
module. This switch is used to reset the storage array
password.
600 W
100–240 VAC (8.6 A–4.3 A)
100 W
Under typical line conditions and over the entire
system ambient operating range, the inrush current
may reach a maximum of 55 A per power supply for
10 ms or less.