Installing The Unit (In-Dash Mounting) - Kenwood dpx-7100dab Bedlenungsanleitung

INSTALLATION/CONNECTION

Installing the unit (in-dash mounting)

Do the required wiring.
( 36, 37)
Dashboard of
your car
When installing without the mounting
sleeve
1 Remove the mounting sleeve and trim plate from the
unit.
2 Align the holes in the unit (on both sides) with the
vehicle mounting bracket and secure the unit with
screws (commercially available).
Use only the specified screws. Using wrong screws might
damage the unit.
Bend the appropriate tabs to hold the
mounting sleeve firmly in place.
How to remove the unit
1 Fit the catch pin on the extraction keys into the holes on
both sides of the trim plate, then pull it out.
2 Insert the extraction keys deeply into the slots on each side,
then follow the arrows as shown on the illustration.
35
ENGLISH