Charging The Robot - Cecotec Conga Y70 Bedienungsanleitung

ENGLISH
- For carpets with fringe or tassels, fold the edge underneath the carpet to prevent
entanglement.
- When the robot is cleaning near open stairs or steps, place a protective barrier to ensure
safe and trouble-free operation. Fig. 6.
- Remove any objects that could become entangled in the robot, such as power cables,
cords, etc. Additionally, if a step is too high, the robot may get stuck.
Useful tips:
For the first use, follow the robot throughout its complete cleaning cycle. This will help you
resolve any minor issues and ensure uninterrupted cleaning. While following it, be careful not
to stand directly in front of the robot.
3.2 Preparation
Before using the product:
1. Remove the protective strip and film. Fig. 7
2. Install the side brushes. Fig. 8

3.3 Charging the robot

1. Place the self-emptying base on the floor against a wall. Make sure there are no stairs,
drops or objects within 1 metre to the left and right of the base, and 2 metres in front of it.
Connect the base to the mains power supply. Fig. 9
Note:
Keep away from objects with highly reflective surfaces such as mirrors or glass.
Keep the self-emptying base away from direct sunlight.
2. Press and hold the power button for 3 seconds to turn on the robot vacuum cleaner and
place it on the self-emptying base. Make sure the charging contacts on both the robot
and base connect properly.
Note:
The robot cannot be charged when it is turned off.
3. When using it for the first time, fully charge the robot. During charging, the Back Home
button will flash blue slowly; the light will remain steady when charging is complete.
Charging time is approximately 4-5 hours.
Important notices:
- During daily use, place the robot vacuum cleaner on the self-emptying base. Also make
sure that the self-emptying base is connected to the power supply and that the robot is
turned on.
- Regularly clean the charging contacts on the base to ensure efficient charging.
22 CONGA Y70