Opening And Closing The Rp562 Rollator; Assembling Model Rp553 - Mopedia Rp562A Gebrauchsanleitung

6

8.2.1 Opening and closing the RP562 rollator

After positioning the rollator so that it is stable on the floor, press down on the sides of the seat
until it opens fully and you hear a clik from below.
To close it again, vigorously lift upward on the belt on the seat.
EN
8.2.2 Inflating tires RP562
To inflate tires use the supplied pump and proceed according to the following steps:
- Unscrew the valve lock cap.
- Snap the pump head onto the valve in place, with the lever in the open open position, (as shown
in fig.1) and push firmly all the way down.
- Lower the pump lever to the closed position (as shown in fig.2).
- After placing the pump on the ground, lower the support base and lock it with your foot (fig.3).
- Start pumping air until the desired tension is reached.
- Remove the pump head from the valve and close it with the cap.
Fig.1
8.2.3 Bag installation
To install the bag, hang the ears of the bag on the seat.
WARNING! Use the basket for small items only. Do not overload the bag to prevent
imbalances and the risk of overturning
8.2.4 Seat
Before sitting , place the rollator on a flat and solid surface and then lock the brakes.
Make sure the latch of the lock is secured properly and that the rollator is in a stable position.
WARNING! Questions to sit down with your weight on the seat assembly.
Do not sit by pushing only on one side.

8.3 Assembling model RP553

- Carefully unpack the product taking care not to damage it.
- Insert the front wheel pivot, into the wheel wells, gently lift the handles of the rollator to a
fully upright position, then open the rollator sideways until the mechanism under the seat
snaps into place, and insert the backrest into the front of the handles (fig.4,5,6).
To close, pull up on the handle on the seat until the rollator son fully closed on the side, and
gently push the handles down.
Fig.2
Fig.3