Getting Started; Inserting / Changing The Batteries - Hama Add-On Bedienungsanleitung

4. Getting started

4.1 Inserting / changing the batteries

Warning - Batteries
• When inserting batteries, note the correct polarity
(+ and - markings) and insert the batteries
accordingly. Failure to do so could result in the
batteries leaking or exploding.
• Only use batteries (or rechargeable batteries) that
match the specied type.
• Beore you insert the batteries, clean the battery
contacts and the polar contacts.
• Do not allow children to change batteries without
supervision.
• Do not mix old and new batteries, or batteries o
dierent types or rom dierent manuacturers.
• Remove the batteries rom products that are not
being used or an extended period (unless these
are being kept ready or an emergency).
1
4
• Press the battery symbol on the housing and pull the housing cover upwards over the control dial.
• Remove the spent batteries and dispose o them i required. Insert two new batteries o type AA. Take care to
ensure the correct polarity as shown in the diagram in the battery compartment.
• "LA" fashes on the display.
• Close the battery compartment by pushing the housing cover back onto the control dial.
• Wait or around 30 seconds until the "LA" display lights up solid. The thermostat can now be tted to the
radiator.
• Do not short-circuit batteries.
• Do not charge batteries.
• Do not burn batteries.
• Keep batteries out o the reach o children.
• Never open, damage or swallow batteries or allow
them to enter the environment. They can contain
toxic, environmentally harmul heavy metals.
• Remove spent batteries rom the product and
dispose o them without delay.
• Avoid storing, charging and using in extreme
temperatures and at extremely low atmospheric
pressures (such as at high altitudes).
2
5
Flashing
3
30 sec.