Putting On The Double Shoulder Strap; Checking The Battery Charge Level; Charging The Battery; Inserting And Removing The Battery - Parkside Performance Ppbs 3 A1 Originalbetriebsanleitung

GB MT
Putting on the double
shoulder strap
DANGER! Risk of accident! Al-
ways wear the double shoulder strap
when working with the device. Always
switch off the device before taking off
the double shoulder strap.
NOTICE! The double shoulder strap is
equipped with a quick release device.
Opening the click fastener (43) re-
leases the device quickly from the
double shoulder strap in a dangerous
situation.
Requirements
• The carabiner (45) is attached to
the eyelet with part of the click
fastener (43).
Procedure (Fig. I)
1. Put the double shoulder strap (42)
on.
2. Adjust the strap length so that the
click fastener (43) is at hip height.
3. Attach the device to the double
shoulder strap (42): Close the click
fastener (43).
4. Place the hip protector (44) on
your hip between your body and
the device.
Checking the battery
charge level
LEDs
red, orange, green Battery charged
red, orange
red
1. Press the button (38) next to the
charge level indicator button (39)
on the battery (37).
The LEDs of the charge level in-
dicator show how much charge re-
mains in the battery.
52
Meaning
Battery partially
charged
Battery needs to
be charged
2. Charge the battery (37) when only
the red LED on the charge level in-
dicator (39) is illuminated.

Charging the battery

See also the charger instruction
manual.
Notes
• If warm, allow the battery to cool
before charging.
• Do not expose the battery to dir-
ect sunlight for long periods and
do not place it on a radiator (max.
50°C).
Charging the battery
1. Remove the battery (37) from the
device.
2. Push the battery (37) into the char-
ging slot of the battery charger
(41).
3. Connect the battery charger (41) to
a power outlet.
4. After charging, disconnect the bat-
tery charger (41) from the mains.
5. Pull the battery (37) out of the bat-
tery charger (41).
Inserting and removing the
battery
WARNING! Risk of injury due to
unintentional start-up. Only insert the
rechargeable battery into the device
once the device is fully prepared for
use.
NOTICE! Risk of damage! An incor-
rect battery can damage the device
and battery.
Inserting the battery
1. Push the battery (37) along the
guide into the battery holder (3).
You will hear the battery click into
place.
Removing the battery
1. Press and hold the battery release
(40) on the battery (37).