Siemens SIMATIC NET S7-1200 Kompaktbetriebsanleitung Seite 10

• EN 61000-6-4 Electromagnetic compatibility (EMC) - Part 6-4: Generic standards - Emission standard for industrial
environments
You will find the current versions of the standards in the currently valid RCM SDoCs (Self-Declaration of Conformity).
KC 요구사항 - For Korea only
A 급 기기(업무용 방송통신기자재)
이 기기는 업무용(A 급) 전자파 적합기기로서 판매자 또는 사용자는 이 점을 주의하시기 바라며, 가정 외의 지역에서
사용하는것을 목적으로 합니다.
FCC
USA
Federal Communications
Commission
Radio Frequency Interference
Statement
Shielded cables
Modifications
Conditions of operations
Responsible party for Supplier's Declaration of Conformity
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
Mail to: (amps.automation@siemens.com)
Siemens Aktiengesellschaft
Digital Industries
Postfach 48 48
90026 NÜRNBERG
GERMANY
Compact Switch Module CSM 1277 G2
A5E54595177-AA, 06/2025
10
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna
• Increase the separation between the equipment and receiver
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected
Shielded cables must be used with this equipment to maintain compliance with FCC
regulations.
Changes or modifications not expressly approved by the manufacturer could void the
user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired
operation.
Compact Switch Module CSM 1277 G2
A5E54595177-AA, 06/2025