Emptying The Coffee Grounds Container; Tips; Preparation; Preparing A Beverage - Beem Coffee-Profession Gebrauchsanleitung

EN

Emptying the Coffee Grounds Container

When the coffee grounds container (8) needs to be emptied, a corresponding message
is shown on the touch display. If necessary, this reminder can be customised (see chapter
'Device settings' - 'Customise reminder to empty the coffee grounds container').
5. Open the door (5) on the side of the device.
6. Pull the coffee grounds container out of the device (picture E).
7. Empty the coffee grounds container over a waste bin and clean it (see chapter 'Cleaning
and care').
8. Put the coffee grounds container back into the device and close the door. It must click into
place.
9. If necessary, touch on the touch display (19) to continue preparation.

Tips

To enjoy an aromatic espresso or coffee, please note the following tips:
Always preheat the cups on the hotplate (1).
•
Rinse out the cups with hot water immediately before using them.
•
Always fill the water tank (4) with fresh water. Do not use any water that has been in the
•
water tank for longer than 12 hours.
If possible, always use freshly ground espresso powder to achieve an optimum flavour.
•
Clean the milk jug (16) and the milk tube (18) as well as the milk system (14) after each use.
•
Regularly clean and descale the device (see the "Cleaning and Care" chapter – "Descaling").
•
A dirty and / or furred-up device compromises the flavour.
46 47

Preparation

PLEASE NOTE!
• Never use the device without a suitable cup below the portafilter.
• For beverage variants for two beverages (e.g. double cappuccino), the cups should
be placed under the coffee spout one after the other.
The completion of the first beverage is indicated by the progress bar on the touch
display: Once this is full, the grinding process for the second beverage starts. Remo-
ve the first cup and place the second cup under the spout.
If the device is in standby mode, switch it on by touching the touch display (19) (see chapter
‚Operation and functions' - ‚Switching the device on / off'). The touch display switches on
and the device carries out the heating process and any cleaning processes in sequence. The
respective step is shown on the touch display. Do not operate the device during this time.
Once all processes are complete, the main menu is displayed. The device is ready for operation.

Preparing a Beverage

1. Prepare the device according to your desired beverage (see chapter ‚Preparation').
2. Remain in the standard menu or select the desired user profile by touching
the desired user profile.
If you want to return to the standard menu, make sure that no user is selected and touch
. You now have the standard settings for all beverages to choose from again.
3. Place a suitable cup on the support plate (10) under the coffee spout (13) and adjust the
height of the spout to the height of your cup if necessary.
4. Touch the image of the desired beverage on the touch display. The beverage is prepared.
To adjust the recipe before preparation, if necessary, follow the instructions in the ‚User
settings' - ‚Adjusting beverages recipes' chapter.
The preparation progress is indicated by the bar on the touch display. As soon as the bar is
filled, the beverage has been completed.
5. If you have selected a beverage option for two drinks, now place the second cup under the
spout. Preparation of the second beverage begins. As soon as the bar is filled, the beverage
is ready.
6. If necessary, switch the device to standby mode (see chapter ‚Operation and functions' -
‚Switching the device on / off').
If no further action takes place, the device automatically switches to standby mode after
a certain time. If necessary, this time can be adjusted (see chapter ‚Device settings' -
‚Adjusting the standby time').
7. Empty the drip tray (12) so that it cannot overflow during further preparation.
EN
and then