Emptying The Sieve Insert For Powder And Pads - Beem 3260 ESPRESSO-PERFECT Bedienungsanleitung

27
Use the small sieve insert for individual pads (6).With E.S.E. (Easy Serving Espresso) pads,
make sure that you place them in the middle of the sieve insert.
2. Use the pressing aid (5) to press down the espresso / coffee powder in the sieve insert.
3. Remove excess espresso / coffee powder from the rim of the portalter or make sure that
the edge of the coffee pad does not protrude.
Filling the Sieve Insert for Capsules
Note that the sieve insert for capsules (10) must be lled before it is inserted in the porta-
lter (9).
1. Reach into the recess on the sieve insert for capsules and ip open the bottom part.
2. Insert the coffee capsule into the sieve insert.
3. Flip the bottom part of the sieve insert down again.
4. Insert the sieve insert into the corresponding portalter (see "Inserting / Removing the Sieve
Insert").
Inserting the Portalter into the Device
1. Hold the lled portalter (8, 9) rmly by the handle and insert it into the device under the
symbol.
2. Turn the portalter to the right (
Removing the Portalter from the Device
1. Hold the portalter (8, 9) by the handle and turn it to the left until it is under the
(Picture F).
2. Pull the portalter down out of the device.

Emptying the Sieve Insert for Powder and Pads

1. Flip up the small lever on the handle of the portalter (8). It stops the sieve insert (6, 7) being
able to fall out when it is emptied (Picture G).
2. Tap out the portalter over a dustbin.
3. Flip the small lever down again and remove the sieve insert from the portalter (see the
"Inserting / Removing the Sieve Insert" section).
4. Clean the sieve insert (see the "Cleaning and Care" chapter).
) until it is under the symbol (Picture E).
EN
symbol