Philips sonicare Advanced Clean Bedienungsanleitung Seite 9

2 Press the power button to turn on your Philips
3 Place the toothbrush bristles against the teeth at a
45°
4 Gently keep the bristles placed on the teeth and in the
45°
5 To clean the inside surfaces of the front teeth, tilt the
6 Begin brushing in section 1 (outside upper teeth) and
1
2
4
3
Sonicare. Then select a brushing mode.
Note: The first 3 seconds of all modes start with a
gentle vibration. This prevents toothpaste from
splattering and lets you cycle through the modes to
select your preferred brushing mode.
slight angle (45 degrees), pressing gently to make the
bristles reach the gumline or slightly beneath the
gumline.
Note: Keep the center of the brush in contact with the
teeth at all times.
gumline. Brush your teeth with small back and forth
motion so the bristles reach between the teeth.
Continue this motion throughout your brushing cycle.
Note: The bristles should slightly flare. It is not
recommended to scrub as you would with a manual
toothbrush.
brush handle semi-upright and make several vertical
overlapping brushing strokes on each tooth.
brush for 30 seconds before you move to section 2
(inside upper teeth). Continue brushing in section 3
(outside lower teeth) and brush for 30 seconds before
you move to section 4 (inside lower teeth).
Note: Additional time is added when you use the
Deep Clean, Gum Pro, or White modes.
11
English