Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Safety regulations
Intended use
The product is intended exclusively for
◆
controlling the points of a model railroad
with magnetic drives.
The product may only be used indoors and
◆
in dry conditions.
The product may only be operated with the
◆
components specified in this manual.
All installation and connection work may
◆
only be carried out with the operating voltage
deactivated.
The product may only be operated with
◆
fused power sources, i.e. protected against
overload and short circuit.
The appliance must not be operated
◆
unsupervised.
The product is not a toy and is not suitable
◆
for children under the age of 14.
Protection against
electric shocks
Moisture, e.g. due to increased humidity or
◆
condensation, can lead to dangerous current
flows through the body and to injuries.
Only operate the product indoors and in dry
◆
conditions.
Avoid any contact of the product with
◆
moisture, wetness or splashing water.
Only touch the product when the
◆
power source is switched off.
Only use voltage sources with low voltages
◆
below 24 volts.
Protection against fire
As a result of a short circuit, overcurrents can
◆
lead to excessive heating of conductor tracks,
components or cables and thus possibly also to
fires.
The product itself is always protected against
◆
overcurrents by appropriate fuses.
Only use tested and approved power
◆
supply units with protection against
overload and short circuit.
The specified maximum permissible loads
◆
must not be exceeded.
Only use cables with sufficient cross-
◆
sections for the loads.
Protect the product from contact with
◆
conductive materials.
Danger due to environmental influences
Avoid thermal and mechanical loads, e.g. from
◆
heat, cold and vibrations,
Pull and push.
Protection against electrostatic discharge
The product contains components that can be
◆
destroyed by electrostatic discharge.
Only touch the product if you have taken
◆
protective measures against electrostatic
discharge, e.g. by wearing ESD protective
tape.
Avoid direct contact with the electronic
◆
components on the circuit board.
3
Werbung
