Further Functions; Auto Zero - Pce Instruments Pce-Rvi 4 Handbuch

Manual
7

Further functions

7.1

Auto zero

If you start a measurement and initiate rotation without immersing the spindle into a fluid and the display
does not show zero, you have to use the auto zero function.
To do so, follow these steps:
Turn on the device by pressing and holding the Enter button for 2 seconds.
When the information screen appears, press the Down button and then the Enter button shortly, one after
the other.
Now you will see this screen:
Press Enter to get to the next screen:
Now, remove the spindle and press Enter again to start the zeroing procedure. During the zeroing, the
display shows the following screen:
After the zeroing was successful, the viscometer automatically goes back to the information screen.
8