Scheppach HL400 Originalbetriebsanleitung Seite 31

- Points of sale of electrical appliances (stationary
and online), provided that dealers are obliged to
take them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical appli-
ance to a private household, the manufacturer can
arrange for the free collection of the old electrical
appliance upon request from the end user. Please
contact the manufacturer's customer service for this.
17. Troubleshooting
The table below contains a list of error symptoms and explains what you can do to solve the problem if your tool fails
to work properly. If the problem persists after working through the list, please contact your nearest service workshop.
Problem
Motor stops starting
Fails to split logs
Log pusher moves
jerkily, taking
unfamiliar noise or
vibrating a lot
Oil leaks around the
cylinder ram or from
other points
Possible Cause
Overload protection device
disengaged to protect the log
splitter from being damaged
Log is improperly positioned
Size of log exceeds the
capacity of the machine
Wedge cutting edge is blunt
Oil leaks
Lack of hydraulic oil and
excessive air in the hydraulic
system
Air sealed in hydraulic system
while operating
Bleed screw is not tightened
before moving the log splitter
Oil drain screw loose
Hydraulic control valve
assembly and/or seal(s) worn
www.scheppach.com
• These statements only apply to devices installed
and sold in the countries of the European Union
and which are subject to the European Directive
2012/19/EU. In countries outside the European Un-
ion, different regulations may apply to the disposal
of waste electrical and electronic equipment.
You can find out how to dispose of the disused de-
vice from your local authority or city administration.
Fuels and oils
• Before disposing of the unit, the fuel tank and the
engine oil tank must be emptied!
• Fuel and engine oil do not belong in household
waste or drains, but must be collected or disposed
of separately!
• Empty oil and fuel tanks must be disposed of in
an environmentally friendly manner.
Remedy
Contact a qualified Electrician.
Refer to "operation" section to perfect log loading
Reduce log size before operating
Sharpen cutting edge
Locate leak(s) and contact your dealer
Check oil level for possible refilling. Contact your
dealer
Loosen bleed screw by some rotations before
operating the log splitter
Tighten bleed screw up before moving the log
splitter
Tighten the oil drain screw firmly
Contact your dealer
GB | 31