CERA-Design RONDOTHERM Anleitung Seite 63

What if...?
... the fire doesn't burn properly?
... the room doesn't get warm enough?
... the room gets too warm?
... smoke comes out when I put fuel on the fire?
Cleaning and Care
What?
Remove ash from the stove.
Clear the stove and chimney flue
pipes from soot depositions
Clean enamelled surfaces.
Clean the glass pane.
Clean heat exchanger fireclay brick
Is the chimney or flue pipe leaking?
•
• Is the chimney properly dimensioned? Are the
cleaning vents open or leaking?
• Is the outside temperature too high?
• Is a door on another fireplace connected to this
chimney open?
Is the heating requirement too high – the stove too
•
small?
Is the firewood too moist?
•
• Is the amount of wood added too small?
Is the supply pressure too high?
•
• Is the amount of wood added too large?
The stove doors were opened too quickly.
•
• The supply pressure is too low.
• The firewood has not yet burnt sufficiently.
How often?
As required, only when cold.
Caution: ash in the combustion
chamber floor must not be removed
completely.
A small ash residue promotes
combustion. CAUTION: always
completely empty the ash pan!!).
After every heating season.
As required, only when cold.
As required, only when cold. Before
spraying the glass pane with glass
cleaner, roll up some paper kitchen
roll into a cylinder and place it in the
door frame at the bottom so that no
cleanser can run between the door
frames and the glass.
As required when cold, at the latest
after each heating period.
62
With w hat?
Remove the ashpan and remove the
remaining ash with an ash shovel and
brush or ash vacuum.
With soot brushes and vacuum
cleaner.We recommend that
maintenance is carried out by a
specialist dealer.
Wipe with clean water and a soft
cloth.
Spray with stove glass cleaner (e.g.
from CERA-Design) and wipe.
Brush off the inclined surfaces using a
soot brush through the combustion
chamber from below; if the flue pipe is
connected at the rear take the cover
off if necessary (see installation of
fireclay heat-storing bricks) and clean
from above. Remove any fallen soot
with an ash vacuum.