Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Configuration
Programming-on-M ain
The decoder can be configured directly at its
◆
place of use from a DCC control center using
Programming-on-Main (PoM).
All CVs can be updated in the process.
◆
The control center must support
◆
PoM for accessory decoders.
To carry out programming in programming-
◆
on-main
mode,
documentation for the control panel used.
Programming track
The decoder can be configured on a
◆
DCC programming track.
All CVs can be read and written via direct mode.
◆
To carry out programming on the
◆
programming track, please refer to the
documentation for the control center used.
Programming
please
refer
to
When configuring using programming on-main,
◆
CVs can only be updated but not read.
There is no feedback about updating a
◆
CV.
It is therefore advisable to check a CV update
◆
immediately.
Changes to the CVs of the decoder are applied
◆
the
immediately, there is no need to restart the
decoder.
decoder is necessary.
The possible values of a CV value are checked
◆
during a write access.
If an attempt is made to write a value to a CV that
◆
is outside the possible values, the write access is
not executed and no confirmation is sent.
Changes to the CVs of the decoder are
◆
immediately, no restart of the decoder is
necessary.
Programming track
10
Werbung
