Concept RM8000 Bedienungsanleitung Seite 31

EN
Grater
IMPORTANT
DO NOT attempt to use this function while grinding, blending or chopping.
1. Cut the food into pieces. Approximately to the size of 20 × 20 × 60 mm so as to be
easily inserted in the opening of the container. Inserted food should not contain
hard parts. Hard parts could cause the motor to stop. If the motor stops, stop the
appliance immediately and unplug it. Remove the entire grater assembly. If the
motor stops automatically, eliminate the cause of the stop. After the motor has
cooled down, it is possible to continue.
2. Switch the appliance on by pressing the speed control button (4) to the speed 5.
3. Place the food in the container exclusively using the stamper.
4. After grinding is completed, turn the speed control button (4) to the "OFF" position
and remove the plug from the wall outlet.
5. Maximum grating time is 5 min. in continuous operation.
Assembly instructions for grater
• Remove the front cover (Fig. 1).
• Place and turn the grater body counter-clockwise so that it clicks firmly into place
(Fig. 2).
• Place the grated food container under the grater.
• Insert the plug into the wall outlet.
• Set the speed control button to position 5. Then place the food in the container and
push it into the container with the stamper.
• After use, switch off the appliance and unplug it.
• Press the grater release button (see Fig. 1). Turn the grater clockwise and remove the
entire grater assembly (Fig. 3).
• Place back the front cover.
1. Fine vegetable grater
2. Coarse vegetable grater
3. Grater for thick slices
4. Grater for thin slices
5. Potato grater
1 2
60
Release
button
Fig. 1
Fig. 2
Fig. 3
3 4 5
Attachment for pasta preparation
IMPORTANT
Do not attempt to use this function at the same time as mixing or stirring!
1. Prepare the pasta dough.
2. Recipe for basic dough: 200g plain flour, 2 eggs, 1 tbsp oil.
3. Switch on the machine using the speed control button (4).
4. Insert the dough slowly into the dough extender, holding the dough with your
hands as it comes out.
5. When finished, turn the speed control knob (4) to the "OFF" position and remove
the plug from the socket.
Installation instructions for the pasta maker attachment
• Remove the front cover (Fig. 1).
• Fit and turn the attachment anti-clockwise so that the latch secures this part firmly
(Fig.2).
• Insert the plug into the socket.
• Use the speed control (4) to select the speed that suits your work.
• After use, switch off the appliance and disconnect it from the mains.
• Press the attachment release button (see Fig. 1). Turn the attachment clockwise and
remove the attachment.
• Replace the front cover.
EN
Release
button
Fig. 1
Fig. 2
61