Completely read through the operating instructions, the "Warranty and
Additional Information" booklet as well as the latest information under
!
the internet link at the end of these instructions. Follow the instructions
they contain. This document must be kept in a safe place and passed
on together with the device.
Intended use
This measuring device is intended for non-destructive measurement of the
material moisture in 56 wood products and 6 building materials using the
capacitive measuring principle. Material moisture is measured by two conductive
sensor pads on the underside of the device and calculated in % with internal
material-dependent characteristics. The value is displayed in % with respect to
dry mass. The measured data can be transferred to the MeasureNote app using
a digital interface connection for record keeping.
The integrated building materials characteristics correspond to the
specified building materials and their designation. Building materials of
the same type but with different designation / composition / strength /
density can however affect the measurement result. Furthermore,
building materials will vary from manufacturer to manufacturer due
!
to the way they are produced. This is why, in the event of different
product compositions or unfamiliar construction materials, a one-off
comparative moisture measurement should be taken using methods
that can be calibrated (e.g. kiln-drying method). If different measured
values occur, they should either be viewed relatively or the index
mode for moisture/drying behaviour should be used.
General safety instructions
– The device must only be used in accordance with its intended purpose
and within the scope of the specifications.
– The measuring tools and accessories are not toys.
Keep out of reach of children.
– Modifications or changes to the device are not permitted, this will
otherwise invalidate the approval and safety specifications.
MoistureMaster Compact Plus
15
EN