Swing BOULDER Montageanleitung Seite 7

Installation instructions
1. Opening the Packaging and Preparations Before the Installation
- Carefully remove the ceiling fan from the packaging and place the fan motor and blades on a cloth or soft surface.
Placing the motor or blades on a hard surface may damage the finish.
- This ceiling fan is provided with a set of matching blades. Do not mix or switch blades from different products. Use of
blades different from those supplied can cause a malfunction and will void your warranty.
- Before starting the installation verify that all the parts are present and available for use, including any accessories which
may be required for the installation. Use only original Swing fan accessories.
2. Hanging Bracket Installation
- There are 4 locking screws on the hanging bracket. Loosen two opposite screws and remove the other two opposite
screws.
- Fix the hanging bracket to a flat surface using suitable fasteners, which should be fastened to a timber joist or concrete
(the attached screws are intended for standard concrete. For other structure types, suitable installation fasteners should
be used).
- All screws provided should be used, and under no circumstances should the Hanging bracket be installed on
Plasterboard only.
Hanging bracket
Screws
7