Swing BOULDER Montageanleitung Seite 13

Setting up the remote control
(If a remote is used and more than one ceiling fan is installed)
Attention! It is required to select a unique frequency value on the remote control for each of the fans.
This is to prevent frequency disruption and interference between the fans.
- Switch off the electricity supply to the fan by turning off the wall switch.
- Open the battery cover located on the back of the remote control.
- Select a unique frequency on the remote control by moving the frequency pins on the back of the remote
control.
- Close the battery cover.
- On the receiver open the black rubber cover and match the frequency that was set on the remote control by
moving the frequency pins.
- Insert the black rubber cover and place the receiver in the hanger bracket and close the ceiling cover.
- Switch back on the electricity supply to the fan.
Receiver Remote control
13