Herunterladen Diese Seite drucken

Swing BOULDER Montageanleitung Seite 15

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
General operating instructions, troubleshooting
Activating the fan
- Ensure that all screws are tightened, and the electrical connections are secure.
for the first time
- Ensure that the fan blades can rotate without any obstructions.
- Ensure that the power is switched on and that the fan is connected to an electrical voltage.
- After you have verified that the fan is supplied with electrical voltage, Switch the fan on to
high speed for about 5 minutes.
Attention! It can take up to 30 seconds for the fan to reach the desired speed.
Troubleshooting
Note! Before starting any troubleshooting or repair activity, ensure that the mains supply
is disconnected.
Does the fan have trouble starting or will the fan not start at all?
- Check all electrical connections, including the wall switch and the circuit breaker in the fuse
box.
- Verify that there is no object/screw that prevents the movement of the blades.
- Ensure that the remote control battery is new and properly inserted.
- Verify that you pressed the fan switch button on the remote control.
- Switch the fan on to the highest speed.
- Verify that the remote control and fan are paired and if necessary re-pair the remote to the
fan (Page 12).
Poor Airflow?
- The fan may rotate in the reverse direction (Winter Mode) – check the Summer/Winter Mode
selection and ensure the mode is appropriately set for the season.
- Verify that the fan is appropriate for the size of the room.
- Check if the space between the ceiling and the blades is less than 20cm. In this case the
airflow will be significantly reduced.
Is the fan noisy?
- If it is a "mechanical" noise, make sure that the blades are tightened, all the screws are
securely tightened, the light fitting is correctly installed, and all the wiring is properly
connected.
- If it is an "electric" noise which is mainly heard in the evening or in the early morning, it may
be caused by electrical pulses which are sent over the electric lines.
Attention! Some noises cannot be prevented and are not covered under warranty.
15

Werbung

loading