Technical Data; Closing The Door; Installation - AEG Electrolux A61600GSW0 Benutzerinformation

14

Technical data

Problem
There is too much frost.

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
TECHNICAL DATA
Dimension of the recess
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.

INSTALLATION

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.
Location
The appliance should be installed well away from sources of heat such as radiators, boil-
ers, direct sunlight etc. Ensure that air can circulate freely around the back of the cabi-
net. To ensure best performance, if the appliance is positioned below an overhanging
wall unit, the minimum distance between the top of the cabinet and the wall unit must
be at least 100 mm . Ideally, however, the appliance should not be positioned below over-
Possible cause
The product temperature is too
high.
Many products are stored at
the same time.
Products are too near to each
other.
Food is not wrapped correctly.
The door is not closed correctly. Refer to "Closing the door".
The temperature regulator is
not set correctly.
Height
Width
Depth
Solution
Let the product temperature de-
crease to room temperature be-
fore storage.
Store less products at the same
time.
Store products so that there is
cold air circulation.
Wrap the food correctly.
Set a higher temperature.
1400 mm
600 mm
630 mm
31 h