Closing The Door; Technical Data; Installation; Positioning - AEG Electrolux A82968-GA2 Benutzerinformation

16

Technical data

Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer to "Installation".
3. If necessary, replace the defective door gaskets. Contact the Service Center.
Technical data
Dimension
Rising Time
The technical information are situated in the rating plate on the internal left side of the
appliance and in the energy label.
Water pressure range
The water pressure must be at least 1 bar
(100kPa)
Highest allowed water pressure 10 bar (1000kPa) If water pressure exceeds 10 bar a reduction
WARNING!
Do not connect the appliance in spaces where ambient temperature can decrease to below
freezing.
The appliance may only be connected to drinking water supplies.
The appliance may only be connected to cold water supplies.

Installation

WARNING!
Read the "Safety Information" carefully for your safety and correct operation of the ap-
pliance before installing the appliance.

Positioning

Install this appliance at a location where the ambient temperature corresponds to the
climate class indicated on the rating plate of the appliance:
Height
Width
Depth
A95288GA
1800 mm
595 mm
650 mm
10 h
Consult your installer if water pressure is less
than 1 bar.
valve must be fitted (available from your spe-
cialist shop.
A82968GA2
1800 mm
595 mm
650 mm
10 h