Replacing The Lamp; Technical Data; Installation - AEG Electrolux A83400HLW0 Benutzerinformation

Replacing the lamp

1. Disconnect the mains plug from the
mains socket.
2. Replace the used lamp with a new lamp
of the same power and specifically de-
signed for household appliances. (the
maximum power is shown on the lamp
cover)
3. Connect the mains plug to the mains
socket.
4. Open the lid. Make sure that the lamp
comes on.
WARNING!
Do not remove the lamp cover at the time of replacement.
Do not operate the freezer if the lamp cover is damaged or missing.

TECHNICAL DATA

Dimensions
Rising Time

INSTALLATION

Positioning
WARNING!
If you are discarding an old appliance that has a lock or catch on the lid, you must ensure
that it is made unusable to prevent young children being trapped inside.
The appliance shall have the plug accessible after installation.
This appliance can be installed in a dry, well ventilated indoor (garage or cellar), but for op-
timum performance install this appliance at a location where the ambient temperature cor-
responds to the climate class indicated on the rating plate of the appliance:
Climate class
SN
N
ST
T
Height × Width × Depth (mm):
876 × 1611 × 665
58 hours
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
Further technical information are situ-
ated in the rating plate on the external
right side of the appliance.
Ambient temperature
17
Technical data