Display And Functions; Normal Operating Mode - Abus RWM120 Bedienungsanleitung

Display and functions

Commissioning
• Press test/reset button and hold it for above 3 seconds until LED lights
red, and release it within 2 seconds, the unit will generate a "beep"
indicates that it is activated and goes into work status.

Normal operating mode

The red LED light under the cover will flash every 40 seconds in normal operating
mode signalling that the alarm is ready for use.
Electronic test
Perform regular functional tests on your smoke alarm, press the test/reset button.
The warning tone will sound and the red 'ALARM' LED light will flash.
This does not signal that there is smoke present in
the room but it is confirmation that the smoke alarm
is functioning correctly.
Always test the functioning of the smoke
alarm after installation. Additionally,
a regular inspection is recommended.
Ensure your hearing is protected by
maintaining an arm's length distance
between yourself and the device!
– 29 –
Display and functions
GB