Werbung
d) Do not restart the cutting operation in the workpiece. Let the wheel reach full speed and carefully
re-enter the cut. The wheel may bind, walk up or kickback if the power tool is restarted in the workpiece.
e) Support panels or any oversized workpiece to minimize the risk of wheel pinching and kickback.
Large workpieces tend to sag under their own weight. Support must be placed under the workpiece
near the line of cut and near the edge of the workpiece on both sides of the wheel.
f) Use extra caution when making a "pocket cut" into existing walls or other blind areas. The
protruding wheel may cut gas or water pipes, electrical wiring or objects that can cause kickback.
Safety Warnings Specific for Sanding Operations:
a) Do not use excessively oversized sanding disc paper. Follow manufacturers recommendations, when
selecting sanding paper. Larger sanding paper extending beyond the sanding pad presents a laceration
hazard and may cause snagging, tearing of the disk or kickback.
Safety Warnings Specific for Polishing Operations:
a) Do not allow any loose portion of the polishing bonnet or its attachment strings to spin freely. Tuck
away or trim any loose attachment strings. Loose and spinning attachment strings can entangle your
fingers or snag on the workpiece.
Safety Warnings Specific for Wire Brushing Operations:
a) Be aware that wire bristles are thrown by the brush even during ordinary operation. Do not
overstress the wires by applying excessive load to the brush. The wire bristles can easily penetrate
light clothing and/or skin.
b) If the use of a guard is recommended for wire brushing, do not allow any interference of the wire
wheel or brush with the guard. Wire wheel or brush may expand in diameter due to work load and
centrifugal forces.
Additional safety Warnings:
a) In tools adapted to attach grinding wheels with a threaded hole, check whether the thread length of the
grinding wheel is suitable for the length of the spindle thread.
b) Secure the workpiece. Attaching the workpiece to the clamping device or vise is safer than holding it
in your hand.
c) Do not touch the cutting and grinding discs until they have cooled down.
d) When using a quick-setting flange, make sure that the internal flange mounted on the spindle is
equipped with a rubber O-ring and that the ring is undamaged. It should also be ensured that the
surfaces of the external flange and the internal flange are clean.
e) Use the quick clamping flange only with abrasive and cutting discs. Only use undamaged and
properly functioning flanges.
f ) In the event of a temporary power outage in the network or after removing the plug from the power
socket with the switch in the „on" position, before re-starting, unlock the switch and set it in the off
position.
CAUTION! This device is designed to operate indoors. The design is assumed to be safe, protection
measures and additional safety systems are used, nevertheless there is always a small risk of injuries
at work.
Descriptions of used pictograms.
1
2
3
1. Warning, take special precautions.
2. Read the instruction manual, observe warnings and safety conditions included in it!
3. Use personal protection equipment (safety goggles, ear protectors).
4. Use safety gloves.
5. Disconnect the power cord, before maintenance or repair works are begun.
6. Keep out of reach of children.
7. Protect against rain
8. Protection class II
4
5
6
18
7
8
Werbung
