Busch+Müller IXON Rock Montage- Und Bedienungsanleitung Seite 23

NOTE Never install brackets on the fork legs or seat stays!
NOTE Never install a bracket on conical components!
Fasten the mounting bracket in a way to ensure the bicycle light cannot move. This is especially
important when riding on uneven surfaces. Enough tightening is achieved when it is difficult to
adjust the position of the light.
WARNING Never adjust the bicycle light while riding! Severe falls and injuries may result.
Do not ride the bicycle if the beam issued by your bicycle light is misaligned, or the light is too
loose. Only straighten or fasten the bicycle light when the bicycle is not moving. Dazzling onco-
ming traffic can cause accidents. Prior to adjusting the bicycle light, always loosen the bracket
screw. Afterwards, make sure to securely re-tighten the bracket screw again.
WARNING Never look into the bicycle light when it is turned on.
23