Busch+Müller IXON Rock Montage- Und Bedienungsanleitung Seite 21

Short screw (30 mm)
Fixing ring
Long screw (55 mm)
Rubber ring
!
Insert the headlight vertically from above into the headlight bracket and press down firmly.
It audibly engages in the locking ring. Make sure it is firmly seated in place. To remove the
headlight, turn the locking ring clockwise, hold the headlight firmly and pull it upwards. We do
not assume any liability in case of drop damage, e.g. because the headlight was not held in place
while releasing the locking ring. If the assembly situation on the bicycle only allows the locking
knob to point away from the cyclist rather than towards him/her, use a screwdriver to unbolt the
bracket on the underside of the headlight, turn by 180° and then fasten again.
21