Making A Measurement - Pce Instruments Pce-Mfm 3800 Bedienungsanleitung

6.4

Making a measurement

After setting all parameters, use the BACK key to return to the measurement screen.
Place the PCE-MFM 3800 sensor into the magnetic flux to be measured. On the measurement
screen, the values of the magnetic flux and temperature appear.
With the navigation keys UP or DOWN, you can display three different screens:
Numerical screen
Graphical screen
Statistical screen
By navigating with the LEFT and RIGHT keys, it is possible to select the measurement range in
the selected unit in manual range or to select auto range. If in manual range, the magnetic flux
is higher than the upper end of the measurement range, "OVERFLOW" is shown on screen. The
measurement ranges are the following.
Auto range
Range 1
Range 2
Range 3
Range 4
Range 5
Range 6
Range 7
Press and hold the BACK key for 2 seconds if you need to reset all measurement values. Press
and hold the HOLD key for 1 second to freeze all measurement values.
Minimum value
Auto range
0
10
100
1k
10k
100k
1M
© PCE Instruments
49
Maximum value
Auto range
10
100
1k
10k
100k
1M
10M