Hold Measurement - Pce Instruments Pce-Mfm 3800 Bedienungsanleitung

•
Using the Auto zero at boot option
This option performs an automatic zero operation when the device is powered on, if it has
been selected. After powering on, the device checks if the magnetic flux around the sensor
probe is below 0.4 mT. If the magnetic flux is higher than this level, a dialogue will appear
on the screen.
If you move the sensor probe to an area where the magnetic flux is below 0.4 mT, the auto zero
operation will be performed.
6.3

Hold measurement

You can hold the current measurement value by pressing and holding the OK key for 1 second
on any measurement screen. When the hold option is activated, "Hold" will appear in the centre
at the top of the screen, below the range bar. The measurement is paused and the values from
the last measurement are retained on the screen.
© PCE Instruments
48