Cleaning And Care - Gastros InductWarm 200 Built-in Betriebsanleitung

Operation
The four power levels of the InductWarm
only. The actual temperature depends on: material of the dish, surrounding temperature, size of the dish and the
positioning above the coil.
The InductWarm 200 has a dish detection. This ensures that the induction field is only active when placing an
®
inductive dish on top. When the InductWarm
will be removed, the InductWarm
indicated by four blinking LEDs. If the dish will be replaced within five minutes the system starts warming on the
same level as before, after that the systems will switch to standby mode. The InductWarm
induction capable dishes.
You can use the touch panel or remote control to operate each individual warming zone separately. This allows you a
very high level of variety in the combination of meals that can be presented. By pressing one of the overall tempera-
ture buttons you can change the temperature level of all zones combined.

Cleaning and Care

Glass ceramic
We recommend using dishes with flat bases to avoid any potential surface damage such as scratches. However, if si-
gns of use like this do appear on your warming surface, it will not impair the warming process in any way.
Cleaning tips:
• First, use a scraper to remove all large pieces of dirt and food leftovers from the warming surface.
• Then squeeze a few drops of a suitable cleaning product on to the cold surface and rub it in with kitchen paper or
a clean cloth.
• Then wipe down the warming surface with water and rub it dry with a clean cloth.
• Clean your warming surface regularly, preferably after each use.
Important: If any plastic objects, aluminium foil, sugar or food containing sugar accidentally melt on to the
hot warming surface, wipe them off the hot warming zone immediately with a cleaning scraper to prevent
surface damage. Never use scouring sponges or scouring products. Chemically aggressive cleaners such as
oven spray and stain remover are also unsuitable.
Daily Cleaning
For cleaning: Switch off the InductWarm
cooled to hand temperature before starting to clean.
Please note: Do not use steel wool or sharp objects. Your induction warming appliance is not splash-water resistant.
Therefore, do not use running water or steam to clean it. To remove dirt and deposits on side walls, you can use
standard pH-neutral cleaning products based on non-ionic and anionic tensides and mild organic solvents such as
alcohol and glycols. Finally, remove all cleaning product residue, wipe down the cleaned surfaces with water, and rub
dry with a dry cloth.
200 cover different warming levels. The temperature levels are indications
®
200 is operating with a dish, the small LEDs are shining. If the dish
®
200 system recognizes the situation and turns off automatically. This is being
®
200 Built-in appliance. Wait until the InductWarm
®
200 can be used wih any
®
200 appliance has
®
19