Initial Start-Up And Operation - Gastros InductWarm 130+ Betriebs- Und Montageanleitung

Initial Start-up and Operation

Remove all remaining packaging and check your InductWarm
appliance if there are any signs of damage. To make it easier to transport your InductWarm
future, please keep the original packaging. The rotary switch must be readily accessible. Do not cover the air inlet area
on the front of the appliance. The air inlet temperature must be lower than 40°C. There must be a gap of at least 5 cm
between the rear of the appliance (air outlet area) and the wall or the closest object.
The InductWarm 130+ can be switched on with the power switch on the bottom of the device. The device is turned on,
®
when the green LED of the power switch and of the power button are shining and the fi rst LED on the front control
panel is blinking.
Your InductWarm can be controlled in diff erent ways:
®
• Using the internal control unit
Repeated pressing of the main switch lets you cycle through the diff erent warming zones 1, 2, 3, 4 and OFF
• Using the external control unit (optinal)
Repeated pressing of the main switch lets you cycle through the diff erent warming zones 1, 2, 3, 4 and OFF.Kindly
fi nd more information in the product specifi ed chapter external control unit.
• Using the infrared remote control (optional)
The power levels can be controlled by the keys 1-4 on the remote control. The device can be switched off by press-
ing the OFF key.
LED Status
• LED 1 is blinking slowly: device in standby mode.
• LEDs are blinking fast: dish has been removed during the operation.
• LED 1 is on = Level 1
• LED 1+2 are on = Level 2
• LED 1+2+3 are on = Level 3
• LED 1 + 2 +3 +3 are on = Level 4
• LED 1+2+3 are on, LED 4 is blinking = automatic power reduction due to overload of the unit
USB Connection
Both software updates and system parameters can be loaded via the USB port. This task should only be performed by
trained service staff .
External Control Unit
• InductWarm ® 130+ can be controlled by an optional, external control unit. This allows a use from the buff et side. For
inserting the cabel, please carefully remove the perforated cover with a side cutter, as shown in the next picture.
• To ensure proper functionality only use cables of Gastros Switzerland AG
18
130+ device for external damage. Do not start up the
®
130+ appliance in the
®