Start-Up, Working With Annular Cutters - Alfra Rotabest Rb 35 B Bedienungsanleitung

COMMISSIONING
Your package contains a fully assembled metal core drilling machine and detailed operating instructions.
Upon receiving your delivery, please check its contents for any transport damage and that you received
everything you ordered. Please instantly contact the manufacturer if you encounter any problems.
!
Always read the operation manual before using the device for the first time!
1. First of all, check the cables and connectors for damages.
2. Plug the safety switch connector into a fused mains socket.
3. Before starting the core drilling machine motor, be sure to press the RESET button to activate the
safety switch. Repeat this step every time you pull the mains plug and every time the safety switch
triggers.
Any improper use of the personal protection switch will result in the exclusion of liability for damage.
Do not position the switch below or in water, as this can cause water to enter and endanger persons
and the machine. Any other incorrect positioning of the switch can also result in the malfunctioning
of the core drilling machine. Furthermore, the personal protection switch is not intended to switch the
machine on and off.
4. Activate the solenoid by pressing the associated switch (Magnet) to ensure that the drill rig reliably
adheres to the workpiece.
• If you are working on non-magnetic materials, please use the ROTABEST Vacubest vacuum
equipment (part no. 18150).
5. Secure Rotabest with a strap when holding the machine vertically up against the wall or ceiling. During
these applications, best practice is to cool the drill bit with a spray (e.g. ALFRA 4000, part no. 21040).
6. Press the green button (Motor) to switch on the drive motor.
7. Repeat the above step to switch the motor off: First of all, press the red button (Motor) to switch off the
motor, then press the Solenoid button to deactivate the solenoid.
Do not use the safety switch as an On/Off switch!
12